• PLAY SERIES - 40s VERY OWN DRUMS Manual
  • Installation and Setup

Installation and Setup

Abstract

Learn how to install and setup 40s VERY OWN DRUMS. Create a Native ID and download the software from Native Access. Follow these installation instructions to get started.

Before you can make music with 40s VERY OWN DRUMS, you must install and setup the necessary software. Follow these instructions to get started:

Native Access

Native Access is where you will install the software for 40s VERY OWN DRUMS. If you are new to Native Instruments, you will first have to create your Native ID. To learn more about Native Access, visit our support page here.

  1. Download and install Native Access here.

  2. Create a Native ID, if you do not yet have one.

  3. Login to Native Access using your Native ID.

  4. Click the Not installed tab.

  5. Click INSTALL for the following products:

    • KONTAKT or KONTAK PLAYER

    • 40s VERY OWN DRUMS

    The software is installed automatically.

Note

If the software is already installed, click the Available updates tab and check for new updates before proceeding.

40s VERY OWN DRUMS via KONTAKT

Once installed, you can start using 40s VERY OWN DRUMS in KONTAKT. 40s VERY OWN DRUMS is not an independent plug-in, so you first need to open an instance of KONTAKT or KONTAKT PLAYER:

  1. Open KONTAKT as a plug-in in your host software (DAW), or as stand-alone application.

  2. Locate 40s VERY OWN DRUMS in the Browser, on the left side of the user interface.

  3. Click Instruments to open the product's content.

  4. Double-click the 40s Very Own Drums.nki file to load the instrument.

    40D_Install.png

Tip

If you are new to KONTAKT and want more information, visit KONTAKT PLAYER and KONTAKT.