Controls in the User Interface
Each user interface in CRUSH PACK features a number of different controls. The following overview explains how to interact with them using a mouse.
Knob Controls
These controls are used to adjust effect parameters. Their value can be changed by clicking on the control and dragging the mouse up and down.
Some knob controls offer additional label buttons that allow you to jump to specific values. For example, you can set DIRT’s Amount control to the DRY, SAT, or FOLD values, or FREAK’s Type control to the AMP, RING, or FREQ values.
The following key commands can be used to alter the behavior of the control:
[Shift] + mouse drag up/down changes the control’s value in fine increments.
[Ctrl] + mouse click sets the control to its default value.
Double click sets the control to the value loaded from the preset or host project.
Button Controls
These controls are used to switch functions on or off. Their value can be changed by clicking on the control.
Some button controls have more than two states. They can be used to toggle between different modes. Their value can be changed by clicking on the control.
Another special button control is FREAK’s FX Mode selector. It allows you to toggle between three distinct modes. Each mode can be activated clicking on the corresponding symbol.
Numeric Controls
These controls are used to adjust effect parameters. Their value can be changed by clicking on the control and dragging the mouse up and down.
The following key commands can be used to alter the behavior of the control:
[Shift] + mouse drag up/down changes the control’s value in fine increments.
[Ctrl] + mouse click sets the control to its default value.
Double click sets the control to the value loaded from the preset or host project.