Spectral Processor
Vocode and Filter your blocks!
DESCRIPTION
Spectral Processor
1.0
____________________________________
NOTE: Attenuator table does not save in between rack instances. Until I can figure that out, if you want the table data saved between sessions, you have to use it in an Ensemble.
____________________________________
This is inspired by the
296 Buchla module.
There are two sections:
ATTENUATOR SECTION
Each band can be controlled by the associated table value, or with CV inputs.
PROGRAM SECTION
FREQ and WIDTH control the peaks that are let through - basically a bandpass filter.
The right hand side is for vocoding. A quick example:
1. Plug your carrier into the EVEN input.
2. Plug your modulator into the ODD input.
3. Activate O -> E mode (Odd envelope followers into the even band amplitudes)
4. Take the audio out of the E (even) output for the PROGRAM section.
5. Adjust the ATTACK and RELEASE times to taste, as well as the FREQ and WIDTH controls for balance.
This works symmetrically if you want the odd input to be the carrier.
You may want to externally highpass your modulator input if it is too bass-y.
COMMENTS (1)